The metal impurity analysis is necessary for the management of metal impurity in many fields, such as impurity element analysis of tap water, ultra‐trace element analysis of semiconductor materials, residual metal analysis of medicine and Biological sample, foods, environment (water/earth), and so on.
The instrumental analysis methods (AAS, ICP-OES, and ICP-MS) are mainly used in metal analysis. There are the following three typical methods.
AAS (Atomic Absorption Spectroscopy)
AAS is a spectroanalytical procedure for the quantitative determination of chemical elements using the absorption of optical radiation (light) by free atoms in the gaseous state. Atomic absorption spectroscopy is based on absorption of light by free metallic ions.
ICP-OES (Inductively coupled plasma optical emission spectroscopy)
ICP-OES is one method of optical emission spectrometry. When plasma energy is given to an analysis sample from outside, the component elements (atoms) are excited. When the excited atoms return to low energy position, emission rays (spectrum rays) are released and the emission rays that correspond to the photon wavelength are measured. The element type is determined based on the position of the photon rays, and the content of each element is determined based on the rays' intensity.
ICP-MS (inductively coupled plasma mass spectrometry)
ICP-MS analysis method uses a high-frequency inductively coupled plasma as ionization source and a Mass Spectrometer as mass/charge filter device. It is ideal for the elemental analysis of sample solutions, in particular where the lowest detection limits are demanded. Due to the increase in the number of analyzed samples, analyzed elements and detection limits in recent years, the ICP Mass Spectrometer has become highly regarded for its speed, accuracy and performance.
|Multi-element Simultaneous Analysis
|Rare Earth, Zr, Ta, P, and B
|FUJIFILM Wako's Grade
|for Atomic Absorption Spectrochemical Analysis, and for JCSS
|for ICP Analysis
FUJIFILM Wako's Elemental Standard Solutions
FJIFILM Wako provide standard solutions suitable for each method, and you can use them according to your purpose.
|for AAS analysis
|for ICP analysis
|Detection of element concentration
|Guaranteed ppb orders using ICP-MS
(with information of impurity elements)
|-Calibration by public institution（CERI)
-Guarantee of the National Measurement Standards Provision System
|-Guarantee of impurity
-Calibrate the concentration using JCSS standard or NIST SRM solutions.
For research use or further manufacturing use only. Not for use in diagnostic procedures.
Product content may differ from the actual image due to minor specification changes etc.
If the revision of product standards and packaging standards has been made, there is a case where the actual product specifications and images are different.