SPE Column for Aldehyde Analysis of Air Pollution
Aldehydes are chemical pollutants in atmosphere and regarded as a cause of sick building syndrome. Aldehydes can be detected by GC or HPLC in general after derivertization to 2,4-dinitrophenylhydrazine (DNPH). In particular, "solid phase extraction & HPLC analysis" is convenient method with easy operation of air sampling and solvent extraction. Our DNPH set is a suitable system for aldehyde analysis.
Specification
Presep®-C DNPH(Short) | Presep®-C DNPH | |
---|---|---|
Filler | crushed silica gel | crushed silica gel |
particle size: 150〜425 μm | particle size: 75〜150 μm | |
pore size: 7.0 nm | pore size: 7.0 nm | |
specific surface: 450 cm2/g | specific surface:450 cm2/g | |
Filler amount | ca. 0.4 g/cartridge | ca. 0.8 g/cartridge |
Amount of DNPH | ca. 0.9 mg/cartridge | ca. 1.8 mg/cartridge |
Size | Length: 3.8 cm | Length:5.0 cm |
maximum width: 1.9 cmφ | maximum width:1.9 cmφ | |
filling part: 1.0 cmφ×0.8 cm | filling part: 1.0 cmφ×1.6 cm | |
Amount of loading sample | ca. 75 μg (as formaldehyde) | ca.150 μg (as formaldehyde) |
Presep® -C DNPH Series
- Reduced noise for lower aldehyde (formaldehyde, acetaldehyde, and acetone)
- Individual packaging
Presep® -C DNPH (Short)
- Easy sampling thanks to excellent permeability
- Good for indoor sampling
Procedure
- Sampling by Presep®C DNPH / Presep®-C Ozone Scrubber
- Extraction by acetonitrile (for aldehyde analysis)
- HPLC analysis (Wakopak® WS DNPH-Ⅱ / Wakosil® DNPH-Ⅱ / eluent A&B / standards)
Example of analysis
Analytical Conditions
Column | Wakosil® DNPH-II 4.6 mmφ, L=150mm | |||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Eluent | A) Wakosil® DNPH-II Eluent A, B) Wakosil® DNPH-II Eluent B | |||||||||||||||
Gradient | 0-10min.: Eluent A=100% → Eluent B/10-16min. → Eluent B=100% | |||||||||||||||
Flow | 1.0 mL/min. at 35°C | |||||||||||||||
UV | 360 nm | |||||||||||||||
Injection | 10 μL | |||||||||||||||
Sample |
|
Product List
- Open All
- Close All
For Aldehyde Analysis Column
Solvent for Exclusive Use
Standard Solution
For research use or further manufacturing use only. Not for use in diagnostic procedures.
Product content may differ from the actual image due to minor specification changes etc.
If the revision of product standards and packaging standards has been made, there is a case where the actual product specifications and images are different.